visitrefa.blogg.se

Getting flightgear rudder to work
Getting flightgear rudder to work







getting flightgear rudder to work

I have modelled the high speed and flaps etc. The JSBSim aerodynamics model uses all of the data in the AFWAL-TR-80-3141 report and is accurate for low speed clean configurations. Using JSBSim for none FDM modelling works well. Once I'd fixed the flight model there were a few changes that just had to be made I felt that the lack of hydraulics and electrics detracted from the realism and provided a challenge to implement these using JSBSim rather than in Nasal. This is my first flightgear model although I've been working with flight simulators for many years professionally. The Flightgear F-14B always had a beautiful 3D model and 3D cockpit thanks to Alexis Bory and Enrique Laso however I felt that the aerodynamics and flight model were not as good and so in August 2014 undertook to fix this using JSBSim and real wind tunnel F-14 aerodynamic data. Recovery procedure is simply to move the throttle for the affected engine to idle and wait for recovery. Monitoring the engine gauges during your scan will allow you to detect a compressor stall by the reduction in RPM. However it is easy to miss this, and particularly on approach when coming in with surplus energy it is possible to keep this in check with rudder and stick and only when increasing power, especially into afterburer, when the yaw moment becomes uncontrollable and an airframe loss is the likely result.

getting flightgear rudder to work

When the compressor stalls there will be a small pop (from the corresponding side). Detecting and handling TF-30 compressor stalls As the compressor stall is based on inlet pressure it is still possible to stall the engine at higher speeds during high G manoeuvering. The compressor stall is simulated based on engine pressures (PB) and the affect of angle of attack and sideslip on the inlet airflow to produce a representative compressor stall. The TF-30 model includes a configurable compressor stall, including MCB failure.

getting flightgear rudder to work

The F-14A with the Pratt and Whitney TF-30 engine is famously sensitive to compressor stalls, and this engine is responsible for many airframe losses.









Getting flightgear rudder to work